Kaabo 10 (2026) – Full Setup, Charging, Controls & Safety GuideUpdated a month ago

📄 Full Manual

You can download the manual here.

📦 What’s Included

• Mantis scooter (handlebar detached)
• Charger
• Tools
• User manual

🧩 Product Overview

Key components:

• Display screen
• Power button
• Throttle (index-finger accelerator)
• Brake levers (front & rear)
• Handlebar
• Bell
• Light switch
• Turn signals
• Folding mechanism
• Charging port
• Kickstand
• Front and rear suspension
• Front and rear motor (depending on model)
• Deck and battery housing

⚙️ Assembly

Steps

1. Remove scooter from packaging carefully
2. Place scooter on floor and deploy kickstand
3. Lift handle post into vertical position
4. Slide locking ring down
5. Close and secure quick-release buckles
6. Attach handlebar to stem
7. Secure using provided screws and metal plate
8. Tighten all bolts securely

👉 Ensure all locking mechanisms are tight before riding

🔁 Folding & Transport

To Fold

1. Loosen quick-release buckles
2. Slide locking ring upward
3. Fold handle post down
4. Hook stem to rear latch

To Carry

• Once folded, carry using stem
• Ensure it is securely locked before lifting

🔋 Charging

Steps

1. Turn scooter OFF
2. Locate and open charging port
3. Connect charger to scooter
4. Plug charger into wall outlet
5. Wait until fully charged
6. Disconnect charger and close port

Charging Indicators

• Red light = charging
• Green light = fully charged

Charging Time

• Mantis 18.2Ah: ~7–9 hours
• Mantis PRO 24.5Ah: ~10–12 hours

🔋 Battery Care

• Charge after each use (recommended)
• Charge at least every 3 months if unused
• Replace battery when capacity drops below ~50%
• Store in a cool, dry place
• Avoid extreme temperatures

👉 Cold temperatures reduce battery performance significantly

⚠️ Charging & Battery Safety

• Use original charger only
• Do NOT charge when wet
• Do NOT charge near flammable materials
• Do NOT leave charging unattended (>24 hours)
• Do NOT charge below 0°C or above 40°C
• Do NOT expose battery to heat, fire, or sunlight
• Do NOT puncture or damage battery
• Do NOT use if battery leaks, smells, or overheats
• Do NOT disassemble battery

👉 Improper use can cause overheating, fire, or injury

🎮 Controls & Operation

Power

• Hold power button for ~2 seconds to turn ON/OFF

Throttle

• Pull accelerator to increase speed
• Stronger pull = faster acceleration

👉 Scooter uses kick-to-start (non-zero start)

• Must be moving before throttle works

Driving Modes

Gear Modes

• Gear 1 = slow
• Gear 2 = medium
• Gear 3 = fast

ECO / TURBO Mode

• ECO → reduced power, longer range
• TURBO → full power, higher speed

SINGLE / DUAL Motor Mode

• SINGLE → rear motor only
• DUAL → both motors active

👉 For max range → ECO + SINGLE
👉 For max performance → TURBO + DUAL

Cruise Control

• Activates after holding constant speed for a few seconds
• Deactivates when braking

Display Information

• Speed
• Battery level
• Trip distance
• Total distance (ODO)
• Voltage
• Time since startup

Advanced Settings (P-Settings)

Includes:

• Speed unit (km/miles)
• Start mode (kick-start vs instant start)
• Cruise control ON/OFF
• Acceleration strength
• Electronic braking (E-ABS)
• Auto power-off timing
• Display brightness
• Torque and braking strength (PRO models)

🛵 How to Ride

1. Wear protective gear
2. Turn scooter ON
3. Place one foot on deck
4. Push off with other foot
5. Place both feet on deck
6. Use throttle to accelerate

Braking

• Use rear brake first
• Then apply front brake to stop fully

⚠️ At high speed:

• Avoid heavy front braking alone (risk of falling forward)

⚠️ Safety Guidelines

MUST DO

• Wear helmet and protective gear
• Inspect scooter before every ride
• Start in low gear when learning

DO NOT:

• Ride in heavy rain or water
• Submerge scooter
• Carry passengers
• Ride at unsafe speeds
• Ride on slippery surfaces
• Ride without proper control or experience

Important Notes

• Max load: 120 kg
• Riders must be 16+ years old
• Braking distance increases in wet conditions
• Components wear over time — inspect regularly

🔧 Maintenance

• Check for loose bolts and screws regularly
• Inspect tires and brakes before riding
• Replace worn components
• Clean using damp cloth only
• Do NOT use chemicals or pressure washers

Brake Maintenance

Mechanical Brakes (18.2Ah)

• Adjust using barrel adjuster if needed

Hydraulic Brakes (PRO)

• Check for leaks and proper pressure

🚨 Pre-Ride Inspection

Before every ride:

• Check brakes are working
• Ensure tires are properly inflated
• Check battery level
• Inspect for loose parts or damage

👉 Stop riding immediately if anything feels off

⚠️ Additional Safety & Usage Notes

• Do not ride indoors
• Do not ride on public roads where prohibited
• Always be aware of pedestrians
• Practice in open areas first
• Do not lend to inexperienced riders

📊 Specifications (Varies by Model)

General

• Max speed: up to ~25 km/h (varies by region/model)
• Range: ~40–90 km depending on battery
• Max load: 120 kg

Battery & Motor

• Battery options:
  • 48V 18.2Ah
  • 60V 24.5Ah
• Motor:
  • Single or dual motor depending on version

Charging

• Charger: 54.6V / 2A
• Charging time: 7–12 hours